8
9
Configuration of the PC
Installing the software
Hardware Setup
Connect the unit to the PC via USB.
New hardware will be found. You have to
install three different device drivers - two
for USB ports and one for the USB camera.
A device driver is software needed by your
PC to communicate with the unit. You will
be asked three times to install a driver.
Note! During driver installation, a message
window could appear, indicating that a particu-
lar driver is not supported or authorized by
Microsoft. Please ignore this message and con-
tinue with the installation.
The Windows Hardware Assistant will guide
you through the installation process. If you are
asked where to look for the drivers, choose
CD-ROM.
In most cases Windows will find the drivers
automatically. It could happen, that Windows
asks for the file STV680u.dll. This file is located
in the drivers folder on the CD.
Software Setup
1. Insert the CD into your CD drive.
2. Double click on setup.exe.
3. Follow the instructions, shown on the
screen.
4. Launch the software.
The software is now ready to use.
Plese read the following information first and
configure language, time, and date if
necessary.
This configuration can be repeated at any time.
Software Language
To choose one of the available languages of the
software, go to “Setup”.
Click on “Language” in the Pull Down menu.
Then make your selection.
To Next Page
Loading...
Need help?
General
