45
Temporary disabling of rating level by DVD disc
If you wish to cancel the set rating level temporarily, select
“Parental Control Level” with
or , then press ENTER. If
the 4-digits password at step 3 on page 43 has been set, the
password entering screen will appear as shown in step 4
below.
Alternatively, if the password has not been set, playback will
commence. If you don’t know (or have forgotten) the pass-
word, select “Cancel Picture”.
The setting screen will disappear. Press OPEN/CLOSE to
remove the disc.
1
Load a DVD disc and press PLAY
or OPEN/CLOSE (see page 29).
2
If the DVD disc has been designed to temporarily cancel the
Rating level, the screen which follows the “Reading” screen
will change, depending on which disc is played. If you select
“YES” with ENTER key, “Your disc exceeds the parental
control level 1.” (e.g.) screen will then appear.
3
Enter the password with
number buttons (0-9).
Then press ENTER.
4
Playback will commence if the entered password was correct.
5
NOTE:
This temporary cancellation of rating level
will be kept until the disc is ejected.
When the disc is ejected, the original rat-
ing level will be set again automatically.
Depending on the DVD disc, the disc may try to temporarily cancel the rating level that you have set.
It is up to you to decide whether to cancel the rating level or not.
If you interrupt the entering,
press RETURN.
Your disc exceeds
the parental control level 1.
Parental Control Level
Cancel Picture
/Enter/Return
Please enter the
4
digit password
9/
Cancel
/ReturnEnter/0
Reading
5M90801A [E] P44-51 28/4/04, 17:3245
To Next Page
Need help?
General
