45
Recording
Manual Focus
Under certain conditions, such as those
listed, you may need to focus manually.
1. Make sure the SCENE SELECT AE
dial is not set to AUTO.
2. Slide the power zoom lever toward T
to zoom in on your subject. To
maintain proper focus throughout the
zoom range, you must zoom in on the
subject before adjusting the focus.
3. Press MODE until FOCUS appears
beside the F1 button in the display
panel. FOCUS appears in the
viewfinder.
4. Press and hold F1 while sliding the
power zoom lever toward T or W to
display a clear picture in the center of
the viewfinder focus.
For slow focusing, slide the power
zoom lever a small amount. For fast
focusing, slide the lever all the way
up or down.
The indicators appear in the
viewfinder. The 5 or
6 indicator will flash. When the
focus cannot be adjusted any farther,
the indicator will flash. When the
focus cannot be adjusted any closer,
the indicator will flash.
5. Release the power zoom lever to lock
in the manual focus. The
indicators appear in the viewfinder.
6. To turn off manual focus, press F1 or
place the SCENE SELECT AE dial to
AUTO. The indicators
disappear from the viewfinder.
Conditions Requiring Manual Focus
• When recording a subject through a
window.
• When recording a subject having a close
foreground and a background that is far
away.
• When recording two subjects at different
distances that overlap in the same scene.
• When the subject is not in the center of
the viewfinder.
• When recording in low-light situations.
• When recording a scene with fast
motions, like a tennis swing.
To Next Page
Loading...
Need help?
General
