17
EN
Cleaning the Disc
A defective or soiled disc inserted into the
unit can cause sound to drop out during
playback.
Handle the disc by holding its inner and
outer edges.
• DoNOTtouchthesurfaceoftheunlabeled
side of the disc.
• DoNOTstickpaperor
tape on the surface.
• Do NOT expose the
disc to direct sunlight
or excessive heat.
•Clean the disc before playback. Wipe
the disc from the center outward with a
cleaning cloth.
• NEVER use solvents such as benzine or
alcohol to clean the disc.
• Do NOT use irregular shaped discs
(example: heart shaped, octagonal, etc.).
They may cause malfunctions.
Cleaning the Unit
• Besuretoturntheunitoffanddisconnect
the power source before maintaining the
unit.
• Wipetheunitwithadrysoftcloth.Ifthe
surfaces are extremely dirty, wipe clean
with a cloth that has been dipped in a
weak soap-and-water solution and wrung
out thoroughly. Then wipe with a dry
cloth.
• Never use alcohol, benzine, thinner,
cleaninguidorotherchemicals.DoNOT
use compressed air to remove dust.
IMPORTANT NOTE
Before transporting the unit, remove any
disc from the disc compartment.
Maintenance
The disc does not play
• Thereisnodiscinsidetheunit(“NoDisc”
appears on the screen).
• Insertthedisccorrectlywiththegraphics
facing up.
• Cleanthedisc.
• Anon-NTSCdischasbeeninserted,orthe
disc region number does not match the
region number of the unit.
• Condensation may have formed inside
the unit due to a sudden change in
temperature. Wait about an hour for it to
clear and try again.