RCA Full Logic Controlled Stereo Cassette Deck User Manual

13
REV
MODE
switch
Starting
playback
button
Playback sequence
15 times relay
(32 sides playback)
*2
*2
I# ∞I @=II # ∞II @=I # ∞I @…
I@=II #∞II @=I #∞I @=II #…
DECK I 3
DECK I 2
Other
deck
mode
15 times relay
(31 sides playback)
15 times relay
(32 sides playback)
15 times relay
(31 sides playback)
*2
*2
DECK II 2
DECK II 3
II# ∞II @=I #∞ I @=II # ∞II @…
II@=I #∞I @=II #∞II@=I #…
PLAYBACK SEQUENCE WITH REV
MODE SWITCH SETTING
The playback sequence depends on the setting
of the REV MODE switch and on which
playback (3 or 2) button is pressed first. The
playback sequence for each possible selection is
shown below.
*2 In the repeat ( ) mode, relay playback
always begins from the forward direction.
I # : DECK I forward playback
I @ : DECK I reverse playback
II # : DECK II forward playback
II @ : DECK II reverse playback
∞ : Auto-reverse function
= : Relay
RELAY PLAYBACK
When relay playback mode is selected,
continuous playback can be performed. When
the tape in the first deck reaches its end and
stops, the other deck will automatically begin
playback.
1. Load prerecorded tapes in DECK I and DECK
II.
2. Set the DOLBY NR switch.
• Always set the switch to the same
positions that was used for recording.
3. Set the REV MODE switch to (See table
under "PLAYBACK SEQUENCE WITH REV
MODE SWITCH SETTING" on this page).
4. Set the stereo amplifier for tape playback.
5. Press the playback (3 or 2) button of the
deck that will start to play first.
• When the tape in one deck ends, the
other deck automatically begins
playback.
• To cancel relay playback, press the stop
(7) button.
NOTES:
• Relay playback can begin from either
DECK I or DECK II.
• The tape in the idle deck can be replaced
during relay playback mode, allowing
many tapes to be played back continu-
ously. This is a convenient feature for
parties, background music, etc.
• When this mode is selected, if the deck
encounters an unrecorded portion of tape
more than 15 seconds in length, it will
fast forward the tape until it encounters
another recorded portion, and resume
playback from that point.
To stop playback temporarily (DECK II
only)
Press the pause (8) button.
• To resume playback, either press the
pause (8) again, or press the playback
(3 or 2) button.
To stop playback
Press the stop (7) button of the operating deck.

RCA Full Logic Controlled Stereo Cassette Deck Specifications

General

Brand	RCA
Model	Full Logic Controlled Stereo Cassette Deck
Category	Cassette Player
Language	English