RCA Full Logic Controlled Stereo Cassette Deck User Manual

15
RECORDING (DECK II ONLY)
RECORDING
1. Load a tape for recording in Deck II.
2. Set the DOLBY NR switch.
3. Set the REV MODE switch.
• To record on one side only, set the switch
to the O position. To record on both
sides, set the switch to the [ position.
4. Press the recording (÷) button.
5. Prepare the audio source from which you wish
to record. Turn on the stereo amplifier and
prepare it for playback of the desired audio
source.
6. Adjust the recording level. For details, see
“ADJUSTING THE RECORDING LEVEL”
below.
7. Press the playback (3 or 2) button or the
pause (8) button to begin recording.
• When recording on both sides, press the
3 button. If the 2 button is pressed,
recording will stop after only one side is
recorded.
To stop recording temporarily
Press the pause (8) button.
• To resume recording, either press the
pause (8) button again, or press the
playback (3 or 2) button.
To Stop Recording
Press the stop (7) button.
Erasure prevention tabs
The recording (÷) button does not work when
the erasure prevention tabs of the loaded
cassette tape have been broken off (See page 6).
Do not press the recording (÷) button with
unreasonable force. When recording on both
sides, make sure that both tabs are intact.
ADJUSTING THE RECORDING LEVEL
The adjustment of the recording level is the
most important factor in achieving good
recording results. A high level provides a good
signal-to-noise ratio and dynamic range, but an
excessively high level distorts the sound. If the
level is set too low for fear of sound distortion,
irritating tape hiss will mar the recording. The
characteristics of tapes differ depending on the
AUTO REVERSE
AUTO TAPE SELECTOR
PLAYBACK
AUTO REVERSE
AUTO TAPE SELECTOR
RECORD • PLAYBACK
SCT-570 FULL LOGIC STEREO CASSETTE DECK
NORMAL
STOP STOP
HIGH REC MUTE RECORD
POWER
EJECT EJECT
— OFF _ ON
HIGH SPEED DUBBING SYSTEM
AUTO MUSIC SEARCH
MIN MAX
REC LEVEL
REV MODE
RELAY/SKIP
COPY I II
3
DECK IIDECK I
DOLBY NR
OFFBC
DECK II
AMS
AMS
+
–
+
–
DECK I
DECK II
$
OSR
1
2 3
67
4
RECORDING MUTE
Use this function to create the 4.5 second blank
space needed for proper operation of the music
search function.
• Press the recording mute (•) button during
recording and the deck will create a blank
space by recording a section which contains
no signal for approximately 4.5 seconds. The
deck will then enter recording standby
mode.
• To create a blank space which is more than
4.5 seconds long, hold the button down for
the desired length of time. When the button
is released, the deck will enter recording
standby mode.
• To resume recording, press the pause (8)
button or the playback (3 or 2) button.
ERASING A TAPE
To erase the recorded contents of a tape, load the
tape in DECK II and follow the procedure below.
AUTO REVERSE
AUTO TAPE SELECTOR
PLAYBACK
AUTO REVERSE
AUTO TAPE SELECTOR
RECORD • PLAYBACK
SCT-570 FULL LOGIC STEREO CASSETTE DECK
NORMAL
STOP STOP
HIGH REC MUTE RECORD
POWER
EJECT EJECT
— OFF _ ON
HIGH SPEED DUBBING SYSTEM
AUTO MUSIC SEARCH
MIN MAX
REC LEVEL
REV MODE
RELAY/SKIP
COPY I II
3
DECK II DECK I
DOLBY NR
OFFBC
DECK II
AMS
AMS
+
–
+
–
DECK I
DECK II
$
OSR
13
2
manufacturer and the type of tape. Set the REC
LEVEL control
so that the level meter’s “–3 dB”
indicator lights steadily most of the time. No
harm will be done if the “0 dB” indicator lights
momentarily at peaks. When recording without
Dolby NR, set the REC LEVEL control so that
the “–3 dB” indicator lights, and the “0 dB”
indicator lights occasionally at peaks.
NOTES:
• The optimal recording level may differ
somewhat depending on the audio source
and type of tape used. In order to obtain the
best possible results, set the recording level
after actual testing. Listen to your recordings,
and adjust the level as necessary.
• The level meter may react differently during
recording and playback of the same tape.
This is due to differences in tape sensitivity,
and creates no problem.
1. Set the REC LEVEL control to the MIN position.
2. Press the recording (÷) button.
3. Press the playback (3 or 2) button or the
pause (8) button.

RCA Full Logic Controlled Stereo Cassette Deck Specifications

General

Brand	RCA
Model	Full Logic Controlled Stereo Cassette Deck
Category	Cassette Player
Language	English