3
A. Press in on the tabs on both sides of
the lens cap to remove it.
2. Attach lens cap cord and
adjust handstrap.
3. Attach shoulder strap.
A. Unfasten one end of the shoulder
strap from the buckle. Make sure
you leave the buckle on the strap.
B. Thread one end of the shoulder
strap through one of the shoulder
strap rings
C. Thread the strap back into the
buckle as shown below. Pull on
the strap and make sure it is
fastened securely before using it to
support your camcorder.
D. Repeat steps A-C for the other end
of the shoulder strap.
B. Attach the lens cap cord to the lens
cap.
C. Pull up the flap of the handstrap
and open the strap.
D. Run the cord from the lens cap
through the A/V terminal cover
and over the end of strap.
E. Adjust the strap for comfort and
close the flap.
Note Make sure the end of the strap is
positioned securely before closing the
flap.
F. Slide the lens cap onto the strap.
First-Time Operation
Cautions: When carrying the camcorder
with the shoulder strap, make sure the
viewfinder is in its down position. This
helps prevent possible damage to the
viewfinder from bumping against your body
as you move.
Make sure the shoulder strap is firmly
attached before using it to carry your
camcorder.
Shoulder Strap Rings
To Next Page
Loading...
Need help?
General
