Remote Control (continued)
18
Replace Remote Battery Cell
1. Turn the remote over. Insert a pencil or paper
clip in the small hole and slide it in the
direction of the arrow while removing the
battery cell holder.
2. Remove the old battery by pushing it to the
front and then up.
3. Insert the lithium cell into cell holder so its
positive (+) terminal faces up.
4. Slide the holder back into the remote until it
clicks into place.
Notes: Never place anything heavy on top of the
remote or lay it upside down.
Replace the cell when the camcorder fails to respond
to the remote.
Remove the cell from the remote if it will not be used
for a month or more. This will prevent possible
damage from leakage. If leakage occurs, wipe up the
liquid inside the compartment, and replace the cell
with a new one.
Cautions: Lithium cell battery. Replace only with 3-Volt micro lithium cell—Duracell No. DL2025.
Use of other cells present a risk of fire or explosion. Must be disposed of properly. Never handle punctured
or leaking cells. May cause burns or personal injury.
Keep out of the hands of children. Can cause death or injury if swallowed. If swallowed, consult a
physician immediately for emergency treatment.
The lithium cell used in this device may explode resulting in a fire or chemical burn if mistreated.
Do not recharge, disassemble, heat above 212˚F (100˚ C), or incinerate.
Never use metallic tweezers to hold the cell, and never short circuit the + and – sides of the battery.
Cell
Cell Holder
Cell
Cell Holder
To Next Page
Loading...
Need help?
General
