EN
Exit Program Mode
Program mode will be deactivated once you
press STOP to end program playback.
Clearing Program List
Your program will be erased once you open the
disc compartment door or change to another
source mode (e.g. radio).
Displaying the Program List
1. While the CD player is stopped, press SET
to enter program mode.
2. Press SET repeatedly to review the
program list.
CD player
Play Mode
Press PLAY MODE/PRESET UP/ once to
repeat entire disc and [REPEAT] icon shows on
display.
Press PLAY MODE/PRESET UP/ twice to
repeat current track and a flashing [REPEAT]
icon shows on display.
Press PLAY MODE/PRESET UP/ a third time
to select random playback. The random
playback icon will be displayed.
Press PLAY MODE/PRESET UP/ a fourth
time to select repeat random playback. REPEAT
and will be displayed.
Programming
When player is in CD stop mode,
1. Press SET . PROG. and TRACK (flashing,
indicating program position) shows on
display.
2. Press TUNE DOWN/BACK or TUNE UP/
NEXT to select the track you want to
store in the program.
3. Press SET again to confirm your selection.
4. Repeat steps 2 to 3 to program to a
maximum of 20 tracks.
5. Press PLAY/PAUSE in program mode to
start program playback (PROG. appears on
display).
-
7
TipTip
TipTip
Tip:
If you are in normal playback
mode but want to play the saved
program. Press
STOPSTOP
STOPSTOP
STOP, then
SETSET
SETSET
SET
and then
PLAY/PAUSEPLAY/PAUSE
PLAY/PAUSEPLAY/PAUSE
PLAY/PAUSE.
To Next Page
Loading...
Need help?
General
