1. Make sure your power cable is connected and the standby red light in the front of
the TV is lit up.
2. Check all your connection cables off the side or the back of your TV and also your
AV devices. Make sure they are all connected securely.
3. Turn on your TV and other AV devices if necessary.
4. Select the correct source according to the Connecting pages.
If an antenna or cable (without a cable box) is connected to your TV’s tuner, you will need to go through
an INITIAL SETUP process in order to watch the TV.
1. Press MENU to open the menu
2. Use the Ż or Ź button to select the CHANNEL icon and press ENTER.
3. Use the Ÿ or ź buttons to highlight the signal type and press Ż or Ź to select your connection
either AIR or CABLE.
4. Use the Ÿ or ź buttons to select AUTO CHANNEL SEARCH and press ENTER to scan for
channels.
5. Once the scanning finishes, you can begin to watch TV.
To Next Page
Loading...
Need help?
General
