RCA RP3740 User Manual

15
Installing Back-up Batteries
Battery Back-Up
The power failure protection circuit
will not operate unless battery is
installed.
When the battery backup functions,
the digital display will not light,
however, the function of wake still
occurs during the power interruption if
remaining battery power is adequate.
Normal operation will resume after AC
power is restored so you will not have
to reset the time or wake.
Installing batteries
1. Unlock the battery compartment
door (located at the bottom of
the radio) by sliding the tab away
from the door.
2. Remove battery compartment door
(located at the bottom of the radio)
by applying thumb pressure to the
tab on battery door and then lift the
door out and off the cabinet.
EN
UM3/AA/LR6
UM3/AA/LR6
UM3/AA/LR6
UM3/AA/LR6
3. Before inserting the batteries,
observe the polarities (That is, + and
-) of the battery, then relate the
polarities to the engraved diagram
inside the battery compartment.
Connect 2 “AA” battery to the
connector plug.
4. Replace the compartment door and
lock the door in place by pushing the
tab towards the compartment door.
NOTE:NOTE:
NOTE:NOTE:
NOTE:
We recommend that you replace the
batteries every 2-3 years.
Power Failure Indicator
When AC power is interrupted
(disconnected) for a short period of time,
both time and alarm settings will change
(unless batteries are installed). After AC
power is restored (reconnected), the
Digital Display will blink to indicate that
power was interrupted and you should
readjust the time and alarm settings.
UM3/AA/LR6
UM3/AA/LR6
MOUNTAIN
PACIFIC
EASTERN
CENTRAL
Untitled-2 4/1/03, 3:48 PM17

RCA RP3740 Specifications

General

Brand	RCA
Model	RP3740
Category	Clock Radio
Language	English