EN
This unit has a built-in automatic time
set system that automatically generates
the correct clock time once the unit is
plugged in. You are not required to set
the clock manually, however, in case
the memory holding batteries are
accidentally removed, you may set the
clock manually with following
procedures:
Setting Clock
1. Be sure Time Zone and Daylight Saving
Time is adjusted before operating the
clock.
2. Press SET CLOCK/WAKE repeatedly
until the clock setting icon is dis-
played.
3. Press REV or FWD to set the time. Press
and hold the respective buttons
to fast reverse or fast forward clock
time.
4. Clock time will automatically be
saved if no buttons are pressed after
a few seconds. You can also press SET
CLOCK/WAKE once to save your set-
ting and return to standby mode.
Note:Note:
Note:Note:
Note:
The clock is in 12 hour
format. The AM and PM
indicators will light to
show am and pm time
respectively.
Setting the Clock
8
To Next Page
Loading...
Need help?
General
