USING TWO VCRS FOR COPYING AND EDITING
TAPES
Use one VCR as the playback VCR and the other as the
recording VCR.
1. Turn on the TV and VCRs.
.
.
.
°
°
.
Tune the TV to the VCR viewing channel (either 3, 4, or TV's
video input).
If you connected your VCR using the ANTENNA jacks, tune
recording VCR to channel 3 or 4ithe one selected on the
back of the playback VCR.
If you have connected your VCR using the audio/video jacks,
press INPUT on the recording VCR's remote to select the line
input.
Insert the tape you want to copy into the playback VCR.
Insert a blank tape with safety tab in place into the
recording VCR.
When you reach the point on the tape or program where you
want to begin copying, press PLAYePAUSE and then
PLAYePAUSEagain on the playback VCR. You may need to
adjust the tracking.
Pressthe RECORD button, then press PLAY.PAUSE, on the
recording VCR.
Pressthe PLAY.PAUSE buttons on both VCRsat the same
time to begin copying the tape.
8. To edit segments that you do not want to copy:
• PressPLAY.PAUSE on recording VCR to stop copying.
• Locate the next segment you want to copy on playback VCR
by using FWD, REV,and PLAY•PAUSE, and then press
PLAY•PAUSE.
PressPLAY•PAUSE on both VCRsat the same time to resume
copying.
9. Press STOP•EJECTon both VCRswhen you are finished.
Caution:
The unauthorized recording of
television programs or other
materials may infringe the rights
of others.
• j
Two VCR Connection
CABLE BOX
OR_"ANTENNA
PLAYBACK VCR
RECORDING VCR
4FI OR
TOTV TOld/
31
To Next Page
Loading...
Need help?
General
