STEP 1: UNPACK _WHAT'S IN THE BOX
The following items come packed in the box:
• VCR
• Remote control
• RF coaxial cable
STEP 2: INSTALL BATFERIES IN THE
REMOTE CONTROL
Follow these steps whenever you need to install or change the
batteries in your VCR remote.
1. Remove the cover of the battery compartment.
2. Place batteries in remote, matching the + and - ends of each
battery to the diagram inside the compartment.
3. Replace the cover.
STEP 3: CONNECT YOUR VCR
If you connect your VCR to your home antenna or cable system
and then to your TV, use the VCR's IN FROM ANTENNA and OUT
TO "IVjacks for a good signal as shown.
If you have a TV with AUDIO/VIDEO jacks, use these jacks for
better picture and sound quality. If you have a stereo TV with left
and right Audio/Video jacks, connect the VCR's AUDIO OUT to
the TV's left audio input. Refer to the Connections section,
toward the back of the manual for more details.
STEP 4: PLUG IN THE VCR
Match the wide blade of the plug with the wide slot in the
outlet. Be sure to insert the plug completely.
VCR
TV
CABLE, CABLE BOX, OR_ANTENNA
AUmO
_@-@
m_@-@
4
To Next Page
Loading...
Need help?
General
