6
Red Sea REEFER
™™
G2+ Series
3 Assembly
The following information complements the graphic manuals.
The REEFER
™
includes the following main components:
• Glass aquarium
• Cabinet (self-assembly)
• ReefMat Ready glass sump with optional Refugium chamber
• Internal Piping kit with outlet nozzle
• ReefATO+ system
• Glass Extension Sump (REEFER 900 G2+ and REEFER-S 850 G2+ / 1000 G2+ /
PS-950 G2+ models only)
Detailed instructions for the complete assembly of the REEFER
™
can be
found in the accompanying graphic manuals.
Complete the assembly of the cabinet including the doors as shown in the
graphic assembly manual and place in the final operating position (see
location above).
The top of the cabinet is approximately 86cm/34” ( 100cm/40” for
Peninsula ) from the floor.
The table shows the approximate weights of the different models of the
REEFER
™
aquarium glass.
Approximate total weight of Aquarium Glass
Model 170 G2+ 200 G2+ 250 G2+ 300 G2+ 350 G2+
Weight 35Kg/
77lb
40kg/
88lb
55Kg/
122lb
58kg/
128lb
64kg/
140lb
Model 425 G2+ 525 G2+ 625 G2+ 750 G2+ 900 G2+
Weight 95kg/
210lb
125kg/
275lb
155kg/
340lb
195kg/
430lb
225kg/
500lb
Model P-350 G2+ P-500 G2+ PS-700 G2+ PS-950 G2+
Weight 101 kg/
223lb
121 kg/
267lb
206 kg/
454lb
251 kg/
553lb
Model S-850 G2+ S-1000 G2+
Weight 226Kg/
500lb
258Kg/
570lb
WARNING: If you are not experienced in the construction of self-
assembly furniture or the installation of aquarium systems,
seek suitably qualified assistance.
ATTENTION: The top board of the cabinet (Part C) and some other parts
of the cabinet (in certain models) are packed under the
aquarium. In order to retrieve these parts, remove the
aquarium from its packaging. Make sure to avoid contact
between the Bulkheads on the bottom of the tank and the
floor, by placing the glass aquarium on Styrofoam parts that
are used in the package.
WARNING: Read before lifting the glass aquarium onto the cabinet.
NOTE: It is important to assemble the REEFER
™
in the order indicated.
To Next Page
Loading...
Need help?
General