Renesas RA6M3 Series User Manual

Renesas RA Family EK-RA6M3 – Quick Start Guide
R20QS0011EU0102 Rev.1.02 Page 7 of 23
Jun.12.20
3. Overview of the Quick Start Example Project
The Quick Start example project allows the user to change the frequency and intensity of the on-board user
LEDs (LED1, LED2, and LED3) using the user buttons (S1 and S2). The supported frequencies are 1 Hz,
5 Hz, and 10 Hz and the supported intensities are 10%, 50% and 90%.
When the EK-RA6M3 board running the Quick Start example project is connected to a host PC via USB as a
Full Speed CDC Device, the kit information, MCU die temperature, user LED blinking frequency, and so
forth, can be displayed on a terminal console.
3.1 Quick Start Example Project Flow
Figure 2. Quick Start Example Project Flow
Next steps are
displayed
No
Power ON/Reset
Is the
S1 (USER BTN)
pressed?
User LEDs
continue to blink at
the same
frequency
Kit Information, MCU
Die Temperature, and
LED Frequency are
displayed
No
No
Yes
2 is pressed
1 is pressed
Yes
User LEDs are blinking
at 1 Hz and 90% intensity
Frequency of the
user LEDs is
changed
Is the
USB connection
established
between the
board and PC?
Welcome
message is
displayed
Enter key is pressed
No
Is the
S2 (USER BTN)
pressed?
User LEDs
continue to blink
at the same
intensity
Yes
Intensity of the
user LEDs is
changed
Yes
Is the Enter key
pressed?
Is a key pressed?

Renesas RA6M3 Series Specifications

General

Brand	Renesas
Model	RA6M3 Series
Category	Microcontrollers
Language	English