Renesas RA6M3 Series User Manual

Renesas RA Family EK-RA6M3 – Quick Start Guide
R20QS0011EU0102 Rev.1.02 Page 8 of 23
Jun.12.20
4. Running the Quick Start Example Project
This section lists the requirements and instructions to power up the EK-RA6M3 board and run the Quick
Start example project.
Hardware Requirements
• EK-RA6M3 board
• Micro USB device cable
• A PC with at least 1 USB port
Software Requirements
• Windows
®
10 operating system
• USB Serial Drivers (included in Windows 10)
• Tera Term (or similar) terminal console application
4.1 Connecting and Powering Up the EK-RA6M3 Board
1. Connect the micro USB end of the micro USB device cable to micro-AB USB Full Speed port (J11) of the
EK-RA6M3 board.
2. Connect the other end of this cable to the USB port of the host PC. Power LED (LED4) on the EK-RA6M3
board lights up white, indicating that the EK-RA6M3 board is powered on.
Note: If the EK-RA6M3 board is not powered through micro-AB USB Full Speed port (J11) and the host PC,
then USB CDC functionality of the Quick Start example project cannot be demonstrated because of
the absence of a USB Full Speed Device connection with the host PC.
Figure 3. Connecting the EK-RA6M3 Board to the Host PC via USB Full Speed Port

Renesas RA6M3 Series Specifications

General

Brand	Renesas
Model	RA6M3 Series
Category	Microcontrollers
Language	English