Air
Standard & Optional Equipment
RGPQ Series
3
WARNING
THIS FURNACE IS NOT APPROVED
OR RECOMMENDED
FOR USE IN MOBILE HOMES
STANDARD EQUIPMENT
Completely assembled and wired; 2 speed draft inducer;
high and low pressure switches; redundant 2 stage main gas
control; blower compartment door safety switch; solid state
time on/time off blower control; limit control; transformer;
direct drive multi-speed blower motor. Furnaces are equipped
with cooling/heating relay and transformer (40VA) ready for air
conditioning applications. (Please note: a thermostat is not
included as standard equipment.) Flame sensor diagnostics;
Twinning options; fused-protection (secondary).
DIRECT SPARK IGNITOR
IN-SHOT BURNERS
INTEGRATED
FURNACE CONTROL
HEAT EXCHANGER
REMOTE SENSOR
TWO-SPEED DRAFT
INDUCER MOTOR
OPTIONAL EQUIPMENT
Side filter frame assembly. Return air cabinet for all sizes.
NOTE: Furnace is not listed for use with fuels other than natural
or L.P. (propane) gas.
The complete terms of limited and other warranties are
available at our sales office, or through local installer.
All models can be converted by a qualified local service
professional to use L.P. (propane) gas without changing
burners. Factory approved kits must be used to convert from
natural to L.P. (propane) gas and may be ordered as optional
accessories.
For L.P. (propane) operation, refer to Conversion Kit Index Form.
To Next Page
Loading...
Need help?
General
