INSTALLATION – CONTROLLERS
66
BATHROOM1 AND BATHROOM2 CONTROLLERS
If only one Bathroom controller is to be installed, the standard Bathroom1 Controller (Rheem PN 299854) or
the Bathroom1 Deluxe controller (Rheem PN 299862) must be used. If two Bathroom controllers are to be
installed, one must be a standard Bathroom1 controller and the other must be a standard Bathroom2
controller (Rheem PN 299855) or one must be a Bathroom1 Deluxe controller and the other must be a
Bathroom2 Deluxe controller (Rheem PN 299863).
They have a minimum temperature setting of 37 C and a maximum temperature setting of:
874 series 50ºC
876 series 48 C
The method of installation for the standard Bathroom1 and Bathroom2 controllers and the Bathroom1 Deluxe
and Bathroom2 Deluxe controllers is identical.
Choose a suitable location for each Bathroom controller, away from water, heat, and sunlight. The Bathroom
controllers are supplied with a 250 mm length of wire with connectors to mate with the Bathroom controller
cable.
Notes:
It is not recommended to have exposed wiring in a bathroom.
Do not apply sealant to the controller cable.
Bathroom1 and Bathroom2 Controller Components
To Next Page
Loading...
Need help?
General
