EasyManuals Logo

Rheem Raypak X94 SR-410 User Manual

Rheem Raypak X94 SR-410
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
13
8.          
including normal snow line.
 
clearance between the ends of vent caps located on
the same horizontal plane.
A
WARNING: The Commonwealth of Massachusetts
requires that sidewall vented heaters, installed in every
dwelling, building or structure used in whole or in part
for residential purposes, be installed using special
provisions as outlined on page 47 of this manual.
Canadian Installations


 Directly above a paved sidewalk or driveway which
      
serves both dwellings.
  
paved driveway located on public property.
 
any building.
        
mm) horizontally of the vertical centerline of the
regulator.
 
outlet.
 
 

air supply inlet to any building or the combustion air
inlet of any other appliance.
8.        

two sides beneath the floor, and the distance between
the top of the vent termination and the underside of
the veranda, porch or deck
Venting Installation Tips


vertical runs—use braces
under or near elbows
A
WARNING: Examine the venting system at least
once a year. Check all joints and vent pipe connections
for tightness, corrosion or deterioration.
Condensate Management
The condensate must be drained properly to protect the
appliance and drainage system. The condensate from

recommends treating the condensate with a Condensate

is connected to the drain system and contains limestone
(calcium carbonate) chips to raise the pH level of the
        
damage to the drainage system and to meet local code
     󰀪   

Vent pipe condensate drains are also required for
       
manufacturer instructions for location of condensate drains
in the vent. The vent condensate should also be routed

code requirements.
The treatment kit must be sized to the condensate
generated by the appliance and the vent.


CAUTION: In general, the condensate piping from
    
horizontal foot. Condensate drain traps must be primed
        
should be checked at least once per year to ensure that
󰀪
should be replenished as necessary. When replacing

blockage in the condensate piping. Figure 6 on page
14 is a visual guide only. Follow the manufacturers
instructions for the installation of the treatment kit and
condensate drains.
A
WARNING: The expected condensate volume shall
not exceed 4 GPH (15 lph).

For heaters connected to gas vents or chimneys, vent


codes.
Vertical Venting (Category
IV) Installation
CAUTION: A listed vent cap terminal, adequately sized,
         
building.
A
CAUTION: This venting system requires the
installation of a condensate drain in the vent piping per
the vent manufacturers instructions. Failure to install a
condensate drain in the venting system will cause non-
warrantable damage. Condensate is acidic and highly
corrosive.
NOTE: Ensure adequate clearances to allow annual
inspection of the venting system.
The connection from the appliance vent to the stack must
be as direct as possible and shall be the same diameter
APPROVED
UNCONTROLLED DOCUMENT IF PRINTED

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rheem Raypak X94 SR-410 and is the answer not in the manual?

Rheem Raypak X94 SR-410 Specifications

General IconGeneral
BrandRheem
ModelRaypak X94 SR-410
CategorySwimming Pool Heater
LanguageEnglish

Related product manuals