29
select valve positions (if used) and turn auxiliary relays on
(if used) for the desired override time period.
RUN SCHEDULE A/B
schedule. The schedules are programmed by pressing
for each day of the week, or for the same schedule every
A and B.
Service Menu and Fault History
To access the Service Menu and Fault History, press the
The heater will continue to operate normally while in the
the MODE button to enter changes and/or move to the
next item.
Table N for a description
of the faults.
Clear Faults – Faults may be cleared by selecting YES and
pressing MODE.
Run Hours/Cycles (view only) – The Run Hours indicates
the total hours of operation for the pool heater, as measured
by the amount of time that the main gas valve has been
cycles of the heater, as measured by the number of times
the main valve has been powered.
Voltage (view only) – Displays the incoming control voltage.
temperature will not be an accurate representation of the
left) and actual (lower right) speeds.
Installer Setup Mode
The Installer Setup Mode is accessed by pressing and
temperature/ignition control board (see Figure 31
top of the heater or by removing the door panel where the
control is mounted (the wiring includes a service loop to
allow the panel to be removed providing access to the board
without removing the wiring). In Installer Setup Mode the
MODE button is used to move between menu items and to
control will exit Installer Setup Mode and any value change
of the current item will not be saved in memory.
Set Current Time
Press MODE to save and move on to the next item.
Set Current Day
the week. Press MODE to save and move on to the next
item.
C/F Display – Celsius or Fahrenheit temperature
scale selection
Celsius for the temperature display. Choose the desired
temperature scale and press MODE to save and move on
to the next item.
Spa Max Temp – Spa Set Point Maximum
Adjustment
spa temperature setting to your desired value. The control
to save and move on to the next item.
Pool Max Temp – Pool Set Point Maximum
Adjustment
pool temperature setting to your desired value. The control
save and move on to the next item.
Heat Selection
operates to provide maximum heat input for the shortest
heat up times.
or Comfort Modulate Selection
reduced operating sound levels by reducing the operating
operates to provide maximum heat input for the shortest
at maximum input until the spa return water temperature
the heater begins to modulate the input rate to match the
APPROVED
UNCONTROLLED DOCUMENT IF PRINTED
To Next Page
Loading...
Need help?
General
