8
4. INSTALLATION
CALIFORNIA PROPOSITION 65 WARNING:
This product contains chemicals known to the State
of California to cause cancer, birth defects or other
reproductive harm.
A
WARNING: This unit contains refractory ceramic
as manufactured, does not contain respirable crystalline
silica. However, following sustained exposure to
very high temperatures (>2192°F [1200°C]), the RCF
can transform into crystalline silica (cristabolite).
The International Agency for Research on Cancer
silica (cristabolite) as carcinogenic to humans.
When removing the burner or heat exchanger, take
precautions to avoid creating airborne dust and avoid
engineering controls such as local exhaust ventilation or
dust collecting systems to minimize airborne dust. Wear
appropriate personal protective equipment including
gloves, safety glasses with side shields, and appropriate
A
WARNING: Improper installation, adjustment,
alteration, service or maintenance may damage the
equipment, creating a hazard resulting in asphyxiation,
warranty.
NOTE: The heater should not be located in an area
where possible water leakage will result in damage to the
area adjacent to the heater or to the structure. When such
locations cannot be avoided, it is recommended that a
suitable drain pan, with adequate drainage, be installed
under the heater. The pan must not restrict combustion
IMPORTANT NOTICE
These instructions are intended only for the use
experienced in the installation of this type of heating
equipment and related system components. Installation
and service personnel may be required by some states to
be licensed. If your state is such, be sure your contractor
not attempt to repair this equipment according to these
instructions.
Installation Codes
Installation must be in accordance with local codes, or,
in the absence of local codes, with the latest edition of
Clearances
All Heaters
For indoor and outdoor clearances from combustible
surfaces see the chart below.
Location Indoor Installation
Top
Front Alcove (Open
Vent
Floor *
Back
Right Side
Left Side
Location Outdoor Installation
Top
Floor
Back
Right Side
Left Side
* Do not install on carpeting
Table C. Minimum Clearances from Combustible Surfaces
from combustible construction, the pool heater can still be
serviced without removing permanent construction around
the heater.
However, for ease of servicing, Raypak recommends a
This will enable the heater to be serviced in its installed
location, without movement or removal of the heater.
NOTE: The heater must be installed in a manner that
will enable the heater to be serviced without removing
any structure around the heater.
FLOORING
The controls are on the angled face, which must be
accessible. Installing the unit in such a way that the controls
are not accessible is not recommended and not supported.
Description Location
Distance
in. (mm)
a.
masonry walls without
ventilated air space
Back
Right
Left
Vent
Indoor Top
Outdoor Top
APPROVED
UNCONTROLLED DOCUMENT IF PRINTED
To Next Page
Loading...
Need help?
General
