When a Message Is Displayed
39
4
When a Message Is Displayed
This section describes the principal messages that appear on the display panel.
If a message not described here appears, act according to the message.
Reference
Before turning the main power off, see “Turning On the Power”, About This
Machine.
Status Messages
This section describes the machine status messages.
Alert Messages
This section describes the machine alert messages.
Message Status
Ready
This is the default ready message. The machine is ready
for use. No action is required.
Printing...
The machine is printing. Wait a while.
Waiting...
The machine is waiting for the next data to print. Wait a
while.
Offline
The machine is offline. To start printing, switch the ma-
chine online by pressing the {Online} Key.
Please wait.
This message may appear for a few seconds. It means the
machine is initializing or executing maintenance opera-
tions. Wait a while.
Resetting Job...
The machine is resetting the print job. Wait until
“
Ready” appears on the display panel.
Setting change...
The machine settings are being changed. Wait a while.
Hex Dump Mode
In Hex Dump mode, the machine prints received data in
hexadecimal format. Turn off the machine after printing,
and then turn back on. Hex Dump mode is used for ad-
vanced troubleshooting.
Message Cause Solution
Problem:Wire-
less card
An error may have occurred in
the IEEE 802.11b card.
Turn off the main power switch,
and back on again. If the message
appears again, contact your sales
or service representative.
Problem:Wire-
less board
An error may have occurred in
the IEEE 802.11b board.
Turn off the main power switch,
and back on again. If the message
appears again, contact your sales
or service representative.
To Next Page
Loading...
Need help?
General
