89
7. Clearing Misfeeds
This chapter describes what to do when paper or originals misfeed (become
jammed inside the machine).
Removing Jammed Paper
WARNING:
CAUTION:
Important
❒ When clearing misfeeds, do not turn off the operation switch. If you do, your
copy settings are cleared.
❒ To prevent misfeeds, do not leave any torn scraps of paper inside the machine.
❒ If paper misfeeds occur frequently, contact your service representative.
Note
❒ More than one misfeed area may be indicated. If this is the case, check every
indicated area. Refer to the following charts: A, B, P, R, Y, and Z.
❒ You can find stickers explaining how to remove misfed paper inside the right
cover and on the top of the ADF or ARDF cover.
❒ When the machine instructs you to reset originals, reset them in the feeding
position. The display will show you the number of originals to return.
• Connect the machine only to the power source described on the inside
front cover of this manual. Connect the power cord directly into a wall
outlet and do not use an extension cord.
• Do not damage, break or make any modifications to the power cord.
Do not place heavy objects on it. Do not pull it hard nor bend it more
than necessary. These actions could cause an electric shock or fire.
• The fusing section of this machine might be very hot. Caution should be tak-
en when removing misfed paper.
AAI030S
To Next Page
Loading...
Need help?
General
