2. Getting Started
This chapter describes how to start using this machine.
Guide to Components
This section introduces the names and functions of the components.
• Do not obstruct the ventilation holes by placing objects near them or leaning things against them. If
the machine overheats, a fault might occur.
Front and left view
1. ADF
If you load a stack of originals in the ADF, the ADF will automatically feed the originals one by one. This ADF
can be used for two-sided originals.
2. Main power switch
If the machine does not operate after turning on the operation switch, check if the main power switch is turned
on. If it is off, turn it on. See “Turning On/Off the Power”.
3. Exposure glass
Place originals face down here.
4. Control panel
See “Control Panel”.
5. Internal tray 1 / Finisher (optional)
Copied/printed paper and fax messages are delivered here.
(The illustration shows the finisher.)
45
To Next Page
Loading...
Need help?
General
