26
Turning the Power On/Off
1.
Press the power button.
After the start sound, the flash lamp and
auto-focus lamp blink alternately for several
seconds.
For power-off, press the power button again.
Caution
It takes longer from power-on until the camera becomes ready for shooting when the flash is
enabled than when it is disabled.
Note
If the LCD monitor does not come on
When the Power-Save mode is set to ON, the LCD monitor does not come on during the
Shooting mode. Turn the mode dial to SETUP to turn the Power-Save mode OFF.
Power-Save mode
The power consumption of the LCD monitor can be reduced and the battery life extended by
setting the Power Saving mode to on.
Auto Power Off
If the camera goes unused for a set period of time, it will automatically turn itself off to save
power. To use the camera again, simply press the power switch.
Reference
• For how to change the Auto Power Off setting, see P.117.
• For how to change the Power-Save Mode setting, see P.119.
To Next Page
Loading...
Need help?
General
