Message Cause Solution
" (Z2) Opn Tray1/R.Cov
& remove ppr. Opn & cls
F.Cov"
Open Tray 1 and the rear cover,
and then remove the jammed
paper. To reset the error, open the
front cover and then close it.
For details, see "Removing
Jammed Paper", Troubleshooting.
"Check you have a print
cartridge replacements."
The toner is almost empty. Prepare a new print cartridge.
" Add toner. Replace Print
Cartridge."
The toner has run out. Replace the print cartridge. For
details, see "Adding Toner",
Maintenance.
"@Remote Cert. update
failed"
Updating the @Remote certificate
failed.
Turn the machine off, and then
turn it on again. If the problem
persists, contact your sales or
service representative.
"Cannot
connect=>Comm.Serv.
Check proxy user/
password."
The proxy user name or password
is incorrect.
Check the proxy server settings,
and then change the user name
and/or password if they are
incorrect.
"Cannot connect with DHCP
server.(101/201)"
An IP address cannot be obtained
from the DHCP server.
Contact your network
administrator.
"Cannot print." The machine cannot print the sent
data.
Check that the file you want to
print is a supported file type.
Check the misfeeds and ask your
network administrator for help.
"Change (Tray name) to the
following settings:"
The size of the paper in the tray
does not match the paper size
specified in the printer driver.
Select a tray containing paper
that is the same size as the
specified paper size.
"Check network settings.
(103/203)"
The IP address setting is incorrect. Check the IP address, subnet
mask, and gateway address.
"Classification Code Error" A classification code is not
specified for the print job.
Enter a classification code using
the printer properties and print the
document again.
"Connect
failed:WirelessCard Turn
power off, check card."
The machine cannot detect the
wireless LAN interface board.
Check that the board is supported
or installed correctly.
5. Troubleshooting
98
To Next Page
Loading...
Need help?
General
