Status Messages
Message Status
"The cooling fan is active." The machine is cooling its interior.
Wait a while, and the machine will resume the print job after the
cooling is complete.
If you use two-sided printing continuously, the machine's interior heats
up, and the machine may temporarily suspend the print job for
cooling.
For people using P 501
If this message appears frequently, dust may have accumulated in the
ventilation holes of the machine. Check the vents, and clean the dust
off. For details, see "Cleaning the Ventilation Holes", Maintenance.
For people using P 502
If this message appears frequently, contact your service representative.
"Energy Saver Mode" The machine is in Energy Saver mode. Press any key to recover to the
normal mode.
"Hex Dump Mode" In Hex Dump mode, the machine receives data in a hexadecimal
format. Turn off the machine after printing, and then turn it on again.
"Job Suspended" All jobs are suspended. Turn off the machine, and turn it on again to
resume the jobs.
"Offline" The machine is offline and cannot print.
"Please wait..." This message may appear for a few seconds. It means the machine is
initializing, replenishing toner, or performing maintenance operations.
Wait a while.
"Printing..." The machine is printing. Wait a while.
"Printing Suspended" Printing is suspended. To resume printing, press the [Suspend/Resume]
key.
"Ready" This is the default ready message. The machine is ready for use. No
action is required.
"Resetting Job" The machine is resetting the print job. Wait a while.
"Setting change..." The machine is applying the changes made to its settings. Wait a
while.
Status Messages
95
To Next Page
Loading...
Need help?
General
