Message Cause Solution
"Set the Print Cartridge
correctly."
The print cartridge may have not
been installed correctly.
Turn the machine off, and install
the print cartridge again.
"Standard Tray is full.
Remove the paper."
The standard tray is full. Remove the paper.
"Supply order has failed." The automatic supply order failed. The message indicates the
machine tried to order the
supplies.
"This NetBIOS name is
already in use.(108/208)"
The NetBIOS name specified for
the machine is already used by
another device on the network.
Contact your network
administrator.
"The same IPv4 Address
already exists.(102/202)"
The IPv4 address specified for the
machine is already used by
another device on the network.
Contact your network
administrator.
"The selected job has
already been printed or
deleted."
This message might appear if you
print or delete a job by using a
web browser on a networked
computer.
Press Exit on the message screen.
"USB has a problem." The machine has detected a USB
board failure.
Turn the machine off, and then
turn it on again. If the problem
persists, contact your sales or
service representative.
"Values set for IPv6/
Gateway addresses are
invalid.(110/210)"
The IPv6 address or gateway
address is invalid.
Check the network settings.
"Waste Toner almost full" The waste toner in the print
cartridge is almost full.
Prepare a new print cartridge.
"Waste Toner Full" The waste toner in the print
cartridge is full.
Replace the print cartridge.
For details, see "Adding Toner",
Maintenance.
"WPA Auth. incomplete.
(211)"
WPA authentication could not be
completed.
Contact your network
administrator.
5. Troubleshooting
102
To Next Page
Loading...
Need help?
General
