Messages during Direct print from a memory storage device
Message Causes Solutions
"Unable to access the
specified memory storage
device."
The memory device used
cannot be recognized.
For details about the recommended
memory devices for the Direct printing
function from memory storage devices,
contact your service representative. The
USB flash memory device that features
password protection or other security
features may not work normally.
"Exceeded the limit value for
total data size of the
selected files. Cannot select
more files."
• The size of the selected
file exceeds 1 GB.
• The total size of the
selected files exceeds
1 GB.
Files or groups of files larger than 1 GB
cannot be printed.
• When the total size of the multiple
files that are selected exceeds 1
GB, select files separately.
• When the size of the selected file
exceeds 1 GB, print by using a
function other than the Direct
printing function from memory
storage devices.
You cannot select files of different
formats at the same time.
Alert Messages (Printed on Error Logs and Reports)
This section describes likely causes of and possible solutions for the error messages that are printed on
the error logs or reports.
Message Cause Solution
"84: Error" There is no work area available
for image processing.
Select [Font Priority] for
[Memory Usage] in [System].
Decrease the number of files
sent to the printer.
"85: Error" The specified graphics library is
unavailable.
Check that the data is valid.
When Messages Are Displayed
83
To Next Page
Loading...
Need help?
General
