RICOH SP C250DN/SP C252DN Color Laser Printers
Getting Started Guide
38
Select 64 bits or 128 bits for the length of the WEP encryption key.
Select an ID number to identify each WEP key in case multiple WEP connections
are configured.
Select a format for entering the WEP key.
Enter the WEP key. The number and type of characters you can enter vary
depending on the length and format selected for the key, as follows:
• WEP key length: [64bits], Format: [Hexadecimal]
WEP key max length: 10 characters (0-9, A-F, a-f)
• WEP key length: [64bits], Format: [ASCII]
WEP key max length: 5 characters (ASCII characters)
• WEP key length: [128bits], Format: [Hexadecimal]
WEP key max length: 26 characters (0-9, A-F, a-f)
• WEP key length: [128bits], Format: [ASCII]
WEP key max length: 13 characters (ASCII characters)
6. When finished, click [OK] to save changes.
7. Close web browser.
8. Disconnect Ethernet cable.
9. Turn printer power switch Off. Wait a moment, and turn On.
10. Next, install Network Printer Driver. See 3.2 Network Printer Driver Install.
Note: For further information on Web Image Monitor, please refer to the Operating Instructions, p101.
Using Infrastructure Mode
Infrastructure mode is the printer’s default communication mode, as most Wi-Fi networks function in this
mode. This enables you to connect the device for communication through a single access point, i.e., your
wireless router.
Note: Ad-Hoc mode, also known as “peer-to-peer” mode, is also supported. Ad-Hoc networks do not
require a centralized access point. Instead, devices on the wireless network connect directly to each other.
For instance, if you set up the two laptops in Ad-Hoc wireless mode, they would connect directly to each
other, without the need for a centralized access point. This would be useful for a temporary connection,
e.g., you’re away from the office/home and need to connect two devices via a Wi-Fi connection to
exchange files or other information when there is no other Wi-Fi network to connect both devices to.
To configure Infrastructure mode, proceed as follows:
1. Check that the wireless router is working correctly.
2. Press [Menu].
3. Scroll [
] to [Host Interface], and press [OK].
4. Scroll [
] to [Network Settings], and press [OK].
5. Scroll [
] to [Wi-Fi Config.], and press [OK].
6. Scroll [
] to [Setup Wizard], and press [OK].
7. Select [Infrastructure], and press [OK].
To Next Page
Loading...
Need help?
General
Weight and Dimensions
