Rigol DS1000B Series Programming Guide

Command Systems RIGOL
Programming Guide for DS1000B Series
2-35
PULSe Trigger
1. :TRIGger:PULSe:MODE
Command Format:
:TRIGger:PULSe:MODE <mod>
:TRIGger:PULSe:MODE?
Function:
The command sets the trigger condition. <mod> can be: +GREaterthan
(positive pulse width greater than), +LESSthan (positive pulse width less than),
+ EQUal (positive pulse width equal), -GREaterthan (negative pulse width
greater than), -LESSthan (negative pulse width less than) or –EQUal (negative
pulse width equal).
Returned Format:
The query returns +GREATER THAN or +LESS THAN, +EQUAL, -GREATER
THAN, -LESS THAN, –EQUAL.
Example:
:TRIG:PULS:MODE +GRE Set the trigger condition as +GREaterthan.
:TRIG:PULS:MODE? Return +GREATER THAN.
2. :TRIGger:PULSe:WIDTh
Command Format:
:TRIGger:PULSe:WIDTh <wid>
:TRIGger:PULSe:WIDTh?
Function:
The command sets the pulse width. The <wid> range is 20ns ~10s.
Returned Format:
The query returns the value of pulse width, and the unit is s.
Example:
:TRIGr:PULS:WIDT 0.001 Set the pulse width as 1ms.
:TRIG:PULS:WIDT? Return 1.000e-003.

Rigol DS1000B Series Specifications

General

Sample Rate	1 GSa/s
Channels	2
Memory Depth	1 Mpts
Vertical Sensitivity	2 mV/div to 10 V/div
Trigger Modes	Edge, Pulse, Video, Slope, Alternate
Vertical Resolution	8 bits
Timebase Range	5 ns/div to 50 s/div
Bandwidth	50 MHz, 100 MHz
Input Impedance	1 MΩ
Interfaces	USB Host, USB Device
Power Supply	100-240 VAC, 45-440 Hz