RIGOL Chapter 18 Store and Load
18-12 MSO7000/DS7000 User Guide
2) Rotate the multifunction knob to select "F" and press down the knob.
The character is displayed in the English selection area.
3) In the English selection area, rotate the multifunction knob to select "F"
and press it down. Then, "F" is displayed in the name input area, "F" is input
successfully. If the character is not found in the current page, press to
go to the next page until you find the desired character.
4. Input the Other Characters
Use the same method to input the remaining letters "ilename" by referring to
Step 3. Pay attention to the upper-lower case of the letters when inputting them.
5. Modify or Delete the Unwanted Characters that Have Been Entered.
While entering a filename, you can modify or delete the unwanted character if
necessary. To delete the input characters, rotate the multifunction knob in
the virtual keypad to select the delete key . Press down the key to delete the
characters. To modify the input characters, delete the unwanted characters and
input the desired characters again. If the character to be modified is in the
middle, press the delete key to delete the characters starting from the last
one to the character to be modified, then input the new character again.
If the touch screen is enabled, tap to directly move the cursor to the character
required to be modified or deleted, and then input the desired character again or
delete the unwanted character.
6. After finishing the input, rotate the multifunction knob and press OK. The
oscilloscope will create a folder or a specified type of file with this name under
the current directory.
Simplified Chinese (or Traditional Chinese) Input Method
For example, create a folder with the name "文件名". Note that the input method of
traditional Chinese is the same as that of the simplified Chinese.
To Next Page
Loading...
Need help?
General
