RIGOL Chapter 7 Remote Control
7-4 RSA3000 User Guide
Remote Control via LAN
1. Connect the analyzer to the PC
Use the network cable to connect the analyzer to the PC or the local area
network (LAN) where the PC resides.
2. Configure network parameters
Sets the network parameters according to the descriptions in "Interface →
LAN".
3. Search for the device resource
Start up Ultra Sigma and click . Then, click in the pop-up
window, and the software starts searching for the analyzer resources connected
to LAN. When a LAN resource is found, its name will be displayed in the resource
box on the right side of the panel. Select the desired resource and click
to add the resource.
Note: The IP address of the selected resource should be consistent with that of
the LAN interface. If you want to remove the resource, please select the
resource name, and then click to remove it.
4. View the device resource
The resources found are shown under the “RIGOL Online Resource” directory.
For example, RSA3045 (TCPIP::172.16.3.194::INSTR).
5. Communication test
Right-click the resource name "RSA3045 (TCPIP::172.16.3.194::INSTR)" and
select "SCPI Panel Control" to turn on the remote command control panel,
through which you can send commands and read data.
6. Load LXI webpage
As the analyzer conforms to LXI CORE 2011 DEVICE standards, you can load LXI
webpage through Ultra Sigma (right-click the instrument resource name and
To Next Page
Loading...
Need help?
General
