Chapter 1 Quick Start RIGOL
RSA3000 User Guide 1-23
Menu Operation
There are 6 types of menus according to their operation modes. Each type of menu
and its operation method are introduced below.
1. Parameter Input
2. State Switching
3. Enter Lower-level Menu (with parameter)
4. Lower-level Menu (without parameter)
5. Direct Execution
6. State Selection
Select the menu and use the numeric keys to modify the
value directly.
For example, to modify center frequency, first select
Center Freq, and then input the desired value. Then,
press Enter to complete parameter input.
For example, select Center Freq and then input the
desired value. Press Enter to complete the center
frequency.
Press the corresponding menu key to switch between
the sub-options.
For example, press Signal Track, and then you can
switch between "On" and "Off" to enable or disable the
signal tracking function.
Press the corresponding menu key to enter the
lower-level menu and change the currently selected
option. The parameter type in the upper-level menu will
be changed when you return to the upper-level menu
again.
For example, press Y Axis Unit to enter the lower-level
menu. Select dBm and then automatically return to the
previous menu automatically. Then, the unit of Y-axis
will be changed to dBm.
Press the corresponding menu key to enter the
lower-level menu.
For example, press Peak Config to enter the
lower-level menu directly.
Press the key to execute the corresponding function.
For example, press Mkr->CF to set the center
frequency of the analyzer to the frequency of the
current marker.
Press the corresponding menu key and modify the
parameters, and then go back to the previous menu.
For example, press Source → Free Run to select free
trigger. The analyzer is in Free Run state at present.
To Next Page
Loading...
Need help?
General
