PP
PP
aa
aa
gg
gg
ee
ee
22
22
11
11
9) To return to the Unset Mode press 0 three
times.
Note:
EN control panel only
.The the log may store up to 256
events with time and date stamp.
Note:
Non EN control panel
. Depending on the Log mode
programmed by your installation engineer the log may store
256 events with no time or date stamp.
or
64 events with time and date stamp.
Keypad Alert
If programmed by your installation company, alarm keys, when
pressed together will act as alert keys. The exact function will depend
on what they have been programmed for. If they are programmed as
panic, for example, pressing them will activate the alarm when the
system is set or unset.
Keypad Tamper
The keypad will monitor the number keys that are pressed without a
valid User Code being entered. More than 24 key presses will cause a
keypad tamper. This will be displayed as and will
require a valid User Code entry to stop the sounders. The display will
then show.
If the system was Unset only the internal sounders will operate. If the
system was Set, a full alarm will be generated.
Tamper
Provision is provided by the control panel for all keypads, cabling and
detectors to be tamper protected. With the system Unset most
tampers will cause an internal alarm, whilst the system is Set a full
alarm will be generated by a tamper.
! ! ! ! CHECK ! ! ! ! !
! ! ! ! CHECK ! ! ! ! !
KP Tamper
To Next Page
Loading...
Need help?
General
