PP
PP
aa
aa
gg
gg
ee
ee
77
77
Resetting After an Alarm
After an alarm the system needs to be reset.
Your installation company will have programmed the reset modes for
your system so that it complies with your insurance company and to
legislation requirements.
Your installation company will have informed you as to the type of
reset that your system is set for.
Before attempting to reset your system, ensure that the system
is Un-set and the fault has been rectified.
1) If the system has been
programmed for An
y code reset;
2) With the display showing:-
Enter your User code.
Then press Yes ( ).
The exit tone will sound and the
display will show:-
3) Enter your User code again to abort the setting.
The system is now reset.
!!!! CHECK ! ! ! ! !
Exit Now ! . . .
Ok !
To Next Page
Loading...
Need help?
General
