78 79
Message
Displayed
Probable Cause / Event
Corrective Action
Cross Outside
The Perimeter Wire is too
close to the edge.
Move the wire towards the inner side of
the lawn.
The lawn slope near the edge
is too steep and causes the
mower to slip outside.
Do not include areas with very steep
slopes.
The lawn’s edge is too bumpy. Fill holes and pits along the edge untill
level with the ground.
Stuck In Place
The mower got stuck in place.
It cannot continue driving.
Check the ground for holes or
indentations. Fill it with soil.
Check if the Perimeter Wire is not too
close to the edge. Move the wire towards
the inner side of the lawn.
Check Mow
Height
Mowing system is in overload
due to very tall grass or an
obstacle that is stuck or
wrapped around the blades.
Turn o the mower and remove the
Disabling device and inspect the blades.
Remove any foreign object or excessive
clogging inside the mowing deck.
Raise the mowing height.
Check Power
There is a temporary power
cut.
Conrm that the Power Supply unit is
plugged in to mains.
The Power Supply unit is not
plugged in properly.
Conrm the Power Supply is properly
connected to the extension cable, and the
cable is connected to the Base Station.
There is no charging source
detected.
Clean the charging contacts on the Base
Station and verify proper connection of
the Base Station to the Power Supply
unit.
No Wire Signal /
Waiting for Signal
Power Supply unit is
unplugged or there is a
temporary power cut.
Make sure the Base Station is connected
to the mains supply.
Signal generator may need to
be restarted.
Disconnect the Power Supply from the
mains supply and reconnect after 10
seconds.
The Perimeter Wire is not
connected to the Base
Station.
Check the connection of the Perimeter
Wire to the Base Station.
The Perimeter Wire is cut. Check for cuts in the Perimeter Wire.
Troubleshooting
7
To Next Page
Loading...
Need help?
General
