10
Functions and details of the app may vary slightly
due to the continuous app development and updates.
Note:
Routine Maintenance
C
C1
Main Brush
* Clean every 2 weeks and replace every 6-12 months
C1-1—Main Brush Cover
C1-2—Latches
C1-3—Main Brush
C1-4—Main Brush Caps
C1-5—Main Brush Bearing
C1-6—Turn over the robot and press the
latches to remove the main brush cover.
C1-8—Rotate the main brush caps in the
indicated unlock direction to remove
the caps.
C1-7—Pull out the main brush and remove
the main brush bearing.
C1-9—Remove any hair or dirt entangled
around the main brush, reinstall the
main brush and re-insert the brush
cover, making sure to place the tabs
in the slots.
C1-10—Make sure that the main brush cover
has been properly attached. When
properly installed, all four tabs should
be hidden.
Notes:
•
Main brush should be wiped down with wet cloth and
left to dry away from direct sunlight.
•
Do not use corrosive cleaning uids or disinfectants to
clean the main brush.
C2
Side Brush
1. Unscrew the side brush screw.
2. Remove and clean the side brush.Reinstall
the brush and tighten the screw.
* Clean monthly and replace every 3-6 months
C3
Omni-Directional Wheel
C3-1—Use a tool, such as a small screwdriver,
to pry out the axle and take out the
wheel.
*
Clean as required
App Features
Cleaning Map
•
Multi-Map Management
•
Real-Time Vacuum and Mop Route
•
Map Zoning
•
Map Editing
Custom Cleaning Modes
•
Scheduled
•
Selective Room
•
Zone
•
No-Go Zones & Invisible Wall
•
Custom
•
Carpet Boost
Cleaning Mode Switch
•
Suction Power Levels
•
Mop Intensity Levels
Robot Information
•
Cleaning History
•
Battery Level
•
Care & Maintenance
More Features
•
Firmware Update
•
Volume Adjustment
•
Language Selection
•
Do Not Disturb mode
•
Voice Assistant Support
The omni-directional wheel bracket cannot be
removed.
Note:
C3-2—Rinse the wheel and the axle with
water to remove any hair and dirt.
Dry and reattach the wheel, pressing
it rmly in place.
Clean the main wheels with a soft, dry cloth.
C4
Main Wheels
*
Clean monthly
C5-4—Fill the dustbin with clean water and
gently shake it. Then pour out the
dirty water.
C5-2—Remove the lter then empty the dustbin.
C5-1—Open the upper cover of the robot
and take out the unit.
C5
Dustbin and Water Tank
Combo Unit
*
Clean weekly and replace the lter every 6-12 months
C5-3—Empty the water tank of unused water.
To Next Page
Loading...
Need help?
General
