08
Slide the mount forwards along the bottom
of robot until it clicks in place.
B4-5—Install the mop cloth mount
Clean the mop cloth after 60 minutes of mopping
to maintain water ow and cleaning quality.
Note:
Open the Roborock App, tap the “Search for
device” button, or open Xiaomi Home app, tap
“+” in the top right corner and add the device
as instructed in the app.
Notes:
•
The actual process may vary due to ongoing app
updates. Follow the instructions provided in the app.
•
Only 2.4 GHz WiFi is supported.
•
If the robot waits more than 1 hour for a connection,
WiFi will be automatically disabled. If you want to
reconnect, reset the WiFi before proceeding.
❸
Add device
Option 2: Search for “Xiaomi Home” in the
App Store or Google Play or scan the QR
code to download and install the app.
When the robot returns to the dock after
cleaning, press the latches on both sides,
and slide the mop cloth mount backwards
to remove it.
B4-6—Remove the mop cloth mount
Notes:
•
Wash the mop cloth after each use, and regularly
empty the water tank of unused water.
•
Remove the mop mount when not mopping.
Connect to the App
Option 1: Search for “Roborock” in the App
Store or Google Play or scan the QR code to
download and install the app.
❶
Download App
This robot supports both Roborock and
Xiaomi Home apps. Choose the one that
best meets your needs.
❷
Reset WiFi
1. Open the upper cover and nd the WiFi
indicator.
If you cannot connect to the robot due to your
router conguration, a forgotten password, or any other
reason, reset the WiFi and add your robot as a new device.
Note:
2. Press and hold the
and buttons until
you hear the “Resetting WiFi” voice alert. The
reset is complete when the WiFi indicator
ashes slowly. The robot will then wait for a
connection.
Only use the ocial Roborock mop cloth.
Note:
Instructions
The robot cannot be turned o when it is being
charged.
Note:
Press and hold the
button to turn on the
robot. The power indicator will turn on and
the robot will enter standby mode. Press
and hold the
button to turn o the robot
and complete the cleaning cycle.
On/O
Press the
button to start cleaning. The
robot will plan its cleaning route according
to its scan of the room. It splits a room into
zones, rst draws out zone edges, and then
lls the zone in a zigzag pattern. In doing
so, the robot cleans all zones one by one,
eciently cleaning the house.
Starting Cleaning
To Next Page
Loading...
Need help?
General
