EasyManuals Logo
Home>Roborock>Vacuum Cleaner>Q7 Max+

Roborock Q7 Max+ User Manual

Roborock Q7 Max+
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11
To prevent blockage, only use clean water without
any cleaning liquid.
Note:
C8-2—Wipe the air duct and cover with a
dry cloth.
C8-3—Reinstall the cover and screw it back
in place.
C8-1—Unscrew the screws (10) and remove
the cover.
C8
Air Duct
*
Replace as needed
C10
Charging Area Cleaning
Clean the dock location beacon, charging
contacts, and electrode brushes with a dry cloth.
*
Clean as needed
Use a soft, dry cloth to wipe and clean all
sensors, including:
C9
Robot Sensors
*
Clean monthly
C9-1—Dock Locator
C9-2—Wall Sensor
C9-3—Four Cli Sensors
Battery
The robot is equipped with a high-performance
lithium-ion rechargeable battery pack. To
maintain battery performance, keep the robot
charged during normal use.
If the robot will be left unused for a long period,
turn it o and charge it at least every three months to
avoid battery damage caused by over-discharge.
Note:
C5-5—Rinse the lter repeatedly and tap it
to remove as much dirt as possible.
C5-6—Allow 24 hours for the filter to dry
thoroughly and reinstall it.
Do not touch the surface of the lter with your
hands, brush, or hard objects to avoid potential damage.
Note:
Purchase an additional lter and alternate if necessary. Note:
C6
Mop Cloth
*
Clean after each use and replace every 3-6 months
Remove the mop cloth from the mop cloth
mount. Clean the mop cloth and air-dry it.
A dirty mop will aect the mopping performance.
Clean it before use.
Note:
C7-2—Lift the dust bag out of the dustbin
and discard it.
C7-4—Install a new dust bag in place along
the slot and put the dustbin cover back.
C7-3—Clean the lter with a dry cloth.
The dust bag handle seals the bag on removal to
prevent dust leakage.
Note:
C7-1—Remove the dustbin cover vertically
as shown.
C7
Dust Bag Replacement
*
Replace as needed
Basic Parameters
Robot
Q380RRModel
14.4V/5200mAh
lithium-ion battery
Battery
Approx. 4.7kg (10.36 lbs)Weight
The serial number is on a sticker on the underside
of the robot.
Note:
< 6 hoursCharging Time
20VDC 1.2ARated Input
Auto-Empty Dock
14.4V/5200mAh
lithium-ion battery
Charging Battery
AED03LRRModel
120VACRated Input Voltage
50-60HzRated Frequency
9.5A
Rated Input
(Dust Collection)
0.5ARated Input (Charge)
20VDC 1.2ARated Output

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Roborock Q7 Max+ and is the answer not in the manual?

Roborock Q7 Max+ Specifications

General IconGeneral
ShapeRound
Product colorWhite
Remotely operatedYes
Dust container typeBagless
Brush typeRoller brush
Efficiency99.7 %
Noise level- dB
Brush materialRubber
Navigation type3D Smart Navigation
Water tank capacity0.35 L
Dust capacity (base)2.5 L
Dust capacity (total)2.97 L
Base station functionsCharging
HEPA filtration system-
Dust capacity (vacuum cleaner)0.47 L
Battery capacity5200 mAh
Suction power4200 Pa

Related product manuals