EasyManuals Logo
Home>Roborock>Vacuum Cleaner>S6

Roborock S6 User Manual

Roborock S6
37 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
Instructions for Use
On / Off
17
Press and hold the buon to power on the main unit.
The power light will turn on and the main unit will enter standby
mode. When the main unit is idle, press and hold the
buon to power off and end the current cleaning cycle.
Note: The main unit cannot be shut down during charging.
Press the buon to start cleaning. When cleaning, the
product will plan an appropriate cleaning path based on the
generated map of the scanned area. It will clean along the edges
of a zone first and then plan a Z-shaped cleaning route to cover
the whole zone efficiently and quickly without missing a spot.
Start cleaning
Notes:
Cleaning cannot be started if the baery level is too low. Recharge baery
then restart cleaning.
Tidy away cables (including the charging dock power cable) from the floor
before cleaning to avoid power failure and to prevent damage resulting from
a dragged cable.
If a cleaning cycle is completed within 10 minutes, by default, cleaning will
repeat.
When the product is running, press any buon to pause it.
Press the buon to restart cleaning or the buon
to end the cleaning cycle and send the product back to the
charging dock.
Pause
Note: Docking the main unit to the charging dock when paused will stop the
current cleaning cycle.
If inactive for more than 10 minutes, the product will enter
sleep mode and its indicator light will flash slowly. Press any
buon to wake the product.
Sleep
Notes:
The product will not enter sleep mode when connected to the charging dock.
The product will automatically shut down if le in sleep mode for over 12 hours.
Zone 1 has
been cleaned.
Zone 2 has
been cleaned.
Zone 4 is
pending.
Zone 3 is
being cleaned.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Roborock S6 and is the answer not in the manual?

Roborock S6 Specifications

General IconGeneral
ShapeRound
Product colorWhite
Remotely operatedYes
Dust container typeBagless
Noise level58 dB
Integrated sensorsAccelerometer, Infrared sensor
Number of programs14
Dust capacity (total)0.48 L
HEPA filtration system-
Floor surfaces supportedCarpet, Hard floor
Threshold climbing (max)20 mm
Battery life250 m²
Battery capacity5200 mAh
Power consumption (typical)58 W
Weight and Dimensions IconWeight and Dimensions
Depth350 mm
Width353 mm
Height96.5 mm

Related product manuals