To Next Page

To Previous Page

_____________________________________________________________________________________________

Portion setting of automatic coffee and hot water portions

The machine must be ready to operate.

Fig. 3 Touchpad

Key 1: For semiautomatic dispensing or portion programming purposes

Key 2,3,4 and 5: For automatic coffee portion control

Key 6: For hot water dispensing with automatic portion control

Setting the coffee portions (Fig. 3 - keys 2,3,4 and 5)

Please use the left side key pad. All coffee portions programmed on these keys

will automatically be programmed also on the same product keys of the other brewing

head. Therefore, there is no need to do the coffee portion settings again on the other

groups.

(You can, of course, program individually every touchpad following the instructions

here below).

Note: We strongly suggest setting the coffee portions under working conditions. This

means using for the product key you wish to set its corresponding filter holder and

basket, with the right amount of properly ground and tamped espresso coffee.

Please proceed as follows:

1. Keep key (Fig. 3-1) pressed until the led of this button is flashing, indicating

that you are in the programming mode. Release key (Fig. 3-1) and press the

“coffee” key to be programmed. The coffee dispensing will start and only

the led of the selected key (and the led of key Fig. 3-1) will be on. When the

desired quantity of coffee has been dispensed, press the product key you

are setting again to stop dispensing. The portion for this product key is set.

Key (Fig.3-1) starts flashing again.

2. Press the next key to program within about 4 seconds (otherwise key Fig.3-

1) will stop flashing indicating that you are not any more in programming

mode). Repeat the above procedure until all coffee portion keys are

programmed.

Rocket Espresso Boxer Series User Manual

Questions and Answers: