portafilter in the group head. Turn the paddle to release heated water and start
the brewing process..
6.
To stop the brewing process return the group control paddle to
the starting position so that the water stops flowing.
7.
To heat milk dip the steam tip under the surface of the milk
which is contained in a stainless milk jug. Release heat into the
milk by pulling the steam handle forwards so the valve is fully
open. Once the milk is at a good temperature for consumption push the lever
back to the upright position. Remove jug from under the steam wand.
8.
In order to prevent heated milk from being sucked into the
boiler it is recommended that you purge the steam wand after
heating milk. Purge by releasing steam for a few seconds into the atmosphere.
9.
To dispense hot water press the hot water symbol on the
touch screen and release the required amount of water into a cup or vessel. To stop
the hot water press the hot water symbol on the touch screen. CAUTION THE
WATER IS VERY HOT.
10.
More details of brewing coffee and steaming milk are outlined in
the Mano section of this Rocket Espresso handbook.
To Next Page
Loading...
Need help?
General
