6
INSTALLATION BASICS:
Before you begin your installation, disconnect the NEGATIVE(-) terminal from your car’s battery. This safety precaution will avoid possible short circuits while wiring your amplier.
Rockville ampliers operate on 12-volt negative ground systems only. It is recommended that you layout your sound system design on paper rst. This will help you during the
installation so that you will have a wiring ow chart and not miss-wire any of your components.
Mount the amplier in the trunk or hatch area of your vehicle. Never install an amplier in the engine compartment or on the rewall. Please be sure to leave breathing room around the
amplier heat sink so that it can dissipate the heat it produces efciently. The amplier can be installed either horizontally or vertically.
When mounting the amplier on the trunk oor, be sure to watch for your gas tank, gas lines and electrical lines. Do not drill or mount any screws where they might penetrate the gas
tank of your car.
MOUNTING THE AMPLIFIER:
The dB Series ampliers feature four mounting tabs located at the ampliers four corners. Choose a convenient mounting location with unobstructed airow. Using the supplied screws
and grommets, gently mount the amplier in to position.
Do not over tighten the screws.
Installation
To Next Page
Loading...
Need help?
General
