77
Troubleshooting
No sound
•If the Monitor level knob is turned too far down, the volume may be too low for you to hear.
Gradually increase the Monitor level knob.
Refer to: “Monitor level knob [MONITOR (PUSH) SELECT]” (p. 13)
• If the output assignments are not set appropriately, sound is not output.
Refer to: “Output assignments” (p. 18)
• Make sure that your headphones or speakers are connected correctly.
No sound from the Internal speakers
• In the system settings for Speaker, make sure that Speaker Switch is ON. No sound is output from the
Internal speakers if this setting is OFF.
• No sound is output from the Internal speakers if headphones are connected.
• To prevent acoustic feedback, no sound is output from the Internal speakers during recording or
recording standby.
• When the sound is too loud, the protection circuit works and sounds stop. Turn the Monitor level
knob left and make volume to adequate level.
Skips occur in the sound
As you repeatedly write and delete project files, the files on the SD memory card become fragmented, and
this slows down the processing speed. If you continue recording in this state, a message of “SD Card Slow!”
is shown, and skips may occur in the recorded project.
If making important recordings, you should consistently delete all projects together when finished with
them. Repeated deletion of smaller pieces of data causes the disk to become fragmented, possibly causing
recording to fail.
Problems with playback
R-44_e_new.book 77 ページ ２００８年１月７日 月曜日 午後５時８分
To Next Page
Loading...
Need help?
General
