38
Playing Techno Sounds
This section explains how to select a tone that was a standard in the Techno boom of the early 80s and use knobs to
adjust the tone in real time. You can use the JUNO-Di’s Arpeggio function and the D Beam controller to give the tone
more of a techno feel.
Playing Techno Sounds
Press the [SYNTH] button.
Use the dial to select “188: BPF Saw.”
˚
Press the [ARPEGGIO] button. The button is lit.
The Arpeggio function switches on and the “ARPEGGIO” screen is displayed.
Use the dial to select “116: Sliced 9 (a)” as the arpeggio style.
The JUNO-Di’s keyboard is not wide enough to play the staff labeled “Play” on the sample score.
So in this section, you use the “Octave Shift” function to shift the key range down an octave and play
the keys an octave higher than the pitches shown on the sample score.
Press the OCTAVE [DOWN] button.
The keyboard’s range is lowered by one octave.
Selecting a Tone
Turning on the Arpeggio Function
Shifting the Keyboard Down an Octave
D Beam Controller
[SYNTH] Button
[CUTOFF] Knob
[RESONANCE] Knob
[SOLO SYNTH] Button [ARPEGGIO] Button
Dial
1
2
1
2
1
JUNO-Di_e.book 38 ページ ２００９年６月２２日 月曜日 午前９時２３分
To Next Page
Loading...
Need help?
General
