Roland M-12E User Manual

[2] Panel Description @ Channel Equalizer Knob
This Knob controls the tone of the input signal. At 0, a
1.
Channel
Section
flat
charactaristic
is
achieved.
a. 2 a. HIGH : Adjusts the upper range. With 10 kHz as the center
aes eee : frequency, adjustment can be made within the
5
SENS.
228
i
range
of
+15
GB.
“soon : LOW : Adjusts the lower range. With 100 Hzas the center
| frequency, adjustment can be made within the
ia a )< (3) range of +15 aB.
dB) | 7
y 20
EFF —o)-[AUK} | - ail
vO. -Z)- PAN ” ( a4 TTT, i val Ue |
(1 Peak Signal Indicator 3 :
When a signal is fed into an Input Jack, the Peak Signal
Indicator willbe green. When the input signal level is too 1
high, the indicator will be red. The indicator willbe green
when the signal is at -20 dB of the rated level (after
passing the input sensitivity circuit) and red at-6dBof 20 iit
the clipping level. ; 20 50 100 200 500 Tk 2k Sk 10k = 20k (Hz)
The Peak Signal Indicator also indicates signal level ® Effect Volume
from the Channel Insert or that have passed the
Channel
Equalizer.
This
knob
adjusts
the
level
of
the
signal
sent
to
the
Effect Send.
Sens
Control
Knob
ai
:
@
Sens
Control
Kno
*
The
signal
sent
to
the
Effect
Send
is
split
after
the
Channel Volume; one portion is sent to the Effect
This knob will control the input sensitivity (depending
Volume, the other is sent to the Master Out.
on the level of the input signal). Set this so that Peak
Signal Indicator will become constantly green and red
during input peaks. If the Peak Signal Indicator do not @ AUX Volume
light at all, raise the Sens Control Knob or increase the
input level. This knob sets the level of the signal sent to the AUX
Send and the position where the signal is split. When
this knob is set to the center position, the signal level is
zero for both PRE signal(signal before being sent to the
Channel Volume) and POST signal(signal after the
Channel Volume). Rotating the knob clockwise will
adjust the POST signal, while rotating it
counterclockwise will adjust the PRE signal.
* The rated input is -60 dBm to +4 dBm.
©) Panpot
This knob controls the placement of the sound in the
stereo image (L+R). At the center position, the sound is
in the center of the field.
@ Channel Volume
This knob controls the level of the signal sent to each
channel. ,
* Channel Volume ”10” is the rated output.

Roland M-12E Specifications

General

Brand	Roland
Model	M-12E
Category	Music Mixer
Language	English