Roland M-12E User Manual

3. Rear Panel
= RETURN
i ckeicheanng tale es MAC Pitot eo eee SEND — .
r = MASTER OUT eed A or
“MASTER ait SS “WONTON out er
sass
@) Input Jacks
Microphones or musical instruments can be connected
using standard phone plugs. |
* This unit employs unbalanced input jacks.
2) Insert Jacks
These are input and output jacks for connecting an
effect unit to a channel. They can also be used for
Channel Direct Out. |
When these jacks are being used for channel direct
output, no signal is sent to the Master Section.
Signal is taken after passing the input sensitivity
circuits, before being sent to the Equalizer section.
To connect an effect device, use an Insert Cable
(PCS-31:optional). To use direct output, use standard
phone plugs.
SEND
RETURN
GND
RETURN (RED) SEND (BLACK) ©
Se rae, Oe
CHANEL INPUT -BOdEm)
[6|0|6[6|6[ol6 6/6|6/6/6)
oi ee Ni
8 2 je. a1.18
“MONITOR ie "anor es
® ©
ee ee. ee
{
2 yy
A) ©) O
: Oda Odie offi Ooi
a A INSERT
UH oo
Ty
|
wart nee |
A
aad
!
= ie GAO | Se ee
@) Return 1 Level switch
This switch selects the input level for Return 1. Change
the position depending on the unit connected to the
mixer.
* Input level of +4 or -20 dBm can be selected.
-@) Return Jacks
These are input jacks for the return signal from an effect
device. They can also be used as AUX inputs. |
The Return Jacks are stereo, but if only the L jack is
used, it will work in monaural.
(6) Effect Send Jack
This is the jack from which the signal is sent to the effect
device.
(6) AUX Send Jack
This is the jack from which the signal is sent to an effect
device or monitor amp.
@ Bus In Jack
This jack allows you to mix the signal directly with the
Effect Send and AUX Send. When stacking two mixers,
you can increase the number of input channels by
sending signals from the Send Jack on the second
mixer to the Bus In Jack on the first mixer.

Roland M-12E Specifications

General

Brand	Roland
Model	M-12E
Category	Music Mixer
Language	English