Settings for the Entire TD (SYSTEM)
39
Loading Data from a USB Flash Drive
Back into the TD (Load Backup)
Data you’ve saved on a USB ash drive can be loaded
back into the TD.
NOTE
• All data and settings in the TD will be overwritten.
• You can’t load data if “Write Protect” (p. 35) is turned
ON.
1. Choose “Load Backup“ and press the [F3]
(ENTER) button (p. 38).
2. Use the value dial to select the data that you
want to load.
3. Press the [F3] (LOAD) button.
A conrmation message will appear.
If you decide to cancel, press the [F1] (CANCEL) button.
4. To load the data, press the [F3] (OK) button.
When the data has been loaded, the screen will indicate
“Completed.”
Deleting Data from a USB Flash
Drive (Delete Data)
Here’s how to delete data that’s been saved on a USB
ash drive.
1. Choose “Delete Data“ and press the [F3] (ENTER)
button (p. 38).
2. Use the cursor buttons ( / ) to choose “Data
Type,” and then use the value dial to choose the
type of data that you want to delete.
Data type Description
1 KIT A drum kit saved by “1 KIT SAVE” (p. 24)
BACKUP Backup data
3. Use the cursor buttons ( / ) to choose “File,”
and then use the value dial to select the number
of the data that you want to delete.
4. Press the [F3] (DELETE) button.
A conrmation message will appear.
If you decide to cancel, press the [F1] (CANCEL) button.
5. To delete the data, press the [F3] (OK) button.
When the data has been deleted, the screen will indicate
“Completed.”
To Next Page
Loading...
Need help?
General